Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

770r3. Common is fl oating. Do not fi t any jumpers. LED lights when output isactive.Caution: Do not exceed the rating of the output. See “Technical Specifi cations”.OverviewProgrammingTo program the unit:a) Connect power.b) Enter programming.c) Select the required operating mode.d) Carry out any learning of detectors or teaching of receivers.e) Program the detailed behaviour for an individual mode.f) Leave programming mode.Note that if you change operating modes then the unit loses all memory ofany transmitters that it has learned.Initial Power Up1. Fit a 6V 1.2Ah battery to the battery brackets, and connect the batterylead to the battery connector (4 on Figure 2).2. Connect a 12VDC supply to 12V/0V In terminals (6 on Figure 2).Caution: Ensure that you connect the power supply to the power input connectorusing the correct polarity.The Power LED glows green.If you wish to run the unit from the battery only, connect the battery and thenbriefl y short the kick start pins (5 on Figure 2) together. This temporarilydefeats the battery saver circuit and allows the module to power up from thebattery. The Power LED fl ashes while the unit is running on battery only.Entering/Leaving ProgrammingTo enter programming:1. Make sure the tamper switch has opened.The Red Trouble LED glows2. Press SELECT.The blue LED for menu 1 glows.To leave programming:1. Press ESC/DEL.10 of 30 Issue 1