Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

4618 Common Output ChannelsManual ResetThe receiver switches a channel ON when itreceives an ACTIVE signal. You must RESET thereceiver to switch the channel OFF. Note that thiswill also switch all other channels to OFF.ToggleThe receiver switches a channel ON when itreceives an ACTIVE signal, and then switches thechannel OFF when it receives the next ACTIVEsignal.Common Output ChannelsWhile in single channel mode (1 to 8) the receiver turns common output AON whenever one of the eight channel outputs is ON.In dual channel mode (9 to 13 and 16 to 19) the receiver turns commonoutput A ON whenever it receives an ACTIVE signal on channel A from atransmitter. The receiver turns common output B ON whenever it receives anACTIVE signal on channel B from a transmitter.Mode Details - Modes 1 To 8Transmitter Set-upFor modes 1 to 8, at the transmitter:• Set switches 1 to 8 to the site code• Set the last four switches as follows:CHANNEL NOSWITCHES9, 10, 11, 121 2 3 45 6 7 8onoffonoffMODE SW SETTING1 1-8 Short Momentary2 1-8 Latching3 1-6 Latching, 7 & 8 Momentary4 1-4 Latching, 5-8 Momentaryon1 2 3 4 5 6 7 8on1 2 3 4 5 6 7 8on1 2 3 4 5 6 7 8on1 2 3 4 5 6 7 8496371 Issue 1 13 of 20