Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

770rMenu Command ReferenceLearn Transmitters (Menu 1)Note: To make the Module learn the identity of a Homelink75 you must setDipswitch 1 to ON.1. Press SELECT until menu 1 appears on the LEDs:(When you enter programming the LEDs showmenu 1 fi rst. You may not need to press Select.)2. Press SET.The LEDs show the state of the unit’s channels.If a LED is fl ashing then the channel has alreadylearned a transmitter. If a LED is off then the channelis free for use.Note: If using IR learn, make sure that the activity LED of the transmitterpoints at the Learn LED of the Module. Hold the transmitter no more than25mm from the Learn LED.3. Trigger the tamper on the detector.The transmitter signals its identity to the unit, andthe unit allocates free channels to the transmitteras required. The sounder gives a double beep andthe LEDs for the newly occupied channels begin tofl ash.4. If necessary, repeat step 3 for any other transmitters.5. Press ESC/DEL. The LEDs show menu 1.Deleting Transmitters (Menu 2)1. Press SELECT until menu 2 appears on the LEDs:12 of 30 Issue 1