MaxSea Operator Manual version 12.6 - Furuno USA

MaxSea Operator Manual version 12.6
Plotting areas
Select Area from the mark type selection box.
The pattern selection box in the lower left-hand corner of the selection boxes is now available (it replaces the line
thickness box).
Click it to call up the pop-up menu and select the pattern that you wish to use to fill the area.
Proceed exactly as in the above paragraph for plotting a line. After double clicking to close, the area is closed and colored
with the pattern selected.
In order to plot a circular area, select Circle (instead of Area) from the mark type selection box. Click the chart, then drag
the mouse and release the mouse button to define the radius of the circle. Note that the circle is colored with the pattern
selected.
116
Note: if you click the chart and do not hold the mouse button down, the software displays the dialog box where
you can enter the circle radius value manually.