MaxSea Operator Manual version 12.6 - Furuno USA

Radar / Chart Offset Direction 0-360
Radar OVERLAY
invalid values are not transmitted to
NavNet.
If (Trail Time > 15 sec), NavNet Radar
will receive all duration values which are
superior to 15 sec.
To define the Chart offset heading:
1. Click on the Radar / Chart Offset
Heading line to display the Pop-up
menu
2. Enter the desired heading offset
from 0 to 360 using arrows or modify
it directly by entering the desired
heading correction value
3. Press [ENTER] to validate.
In some instances position may be off by
a few seconds. For example, the position
of the ship is shown to be at sea while it
is in fact moored at a pier. You can
compensate for this error by offsetting
chart position
Radar / Chart Offset Distance 0-100 To define the Chart offset Distance:
NavNet Radar Signal Processing Settings
SIGNAL
PROCESSING
1. Click on the Radar / Chart Offset
Distance line to display the Pop-up
menu
2. Enter the desired distance offset
from 0 to 100 using arrows or modify
it directly by entering the desired
distance correction value
3. Press [ENTER] to validate.
Option Range Operation
Echo Stretch - Off
- Low
- High.
To set the Echo Stretch type:
1. Click on the Echo stretch line to display the Pop-up menu
2. Choose HIGH, LOW as appropriate or OFF for no Echo Stretch
3. Press [ENTER] to validate.
Normally, the reflected echoes from long range targets appear on the display as
weaker and smaller blips even though they are compensated by the radars internal
circuitry. The echo stretch function magnifies these small blips in all ranges. Two
types of echo stretch are available: LOW which stretches echoes in bearing direction
385