MaxSea Operator Manual version 12.6 - Furuno USA

• Click on a zone to select it.
• Then click the upper left-hand corner or the lower right-hand corner of the selected zone and drag the
mouse to modify the size of the zone.
Note:
by clicking this zone, you move it into the foreground.
Be careful Zones should not overlap. If the modifying zone covers other zones the visible zone becomes
prioritary.
Modifying the zone name
Click the zone to select it and then enter the new name in the Title box.
Modifying the color of the zone
Erasing a zone
Creating a zone
Click the zone to select it then call up the color pop-up menu.
Click the zone to select it, then select Erase from the Edit menu.
Seabed Analysis
Click outside of the existing zone. Next, drag the mouse holding its button down to define the new zone.
Then, enter the associated parameters (name, color) as explained above.
Note: 16 zones max can be created.
Displaying the selection
If points to which (E1/E2) information is associated are selected on the chart, a "S" button appears in the
upper left corner Ground discrimination palette
303