MaxSea Operator Manual version 12.6 - Furuno USA

may be missed.
FTC % 0-100 To adjust the FTC level:
Noise
Rejection
Tune
Auto/Manual
Tune
Control
2nd Echo
Rejection
- Off
- Low
- High.
-
Automatic
- Manual
1. Click on the FTC line to display the Pop-up menu
Radar OVERLAY
2. Adjust the range from 0 to 100% using arrows or modify it directly by entering
the desired percentage value
3. Press [ENTER] to validate.
Note : Do not overadjust the FTC weak target echoes may be
missed.
Note:Available with Model 1700 series radar. Inoperative otherwise.
To suppress rain clutter from heavy storms or scattered rain clutter, adjust the FTC.
The FTC splits up these unwanted echoes into a speckled pattern, making
recognition of solid targets easier.
Note: In addition to reducing clutter, the FTC can be used in fine weather to clarify
the picture when navigating in confined waters. However, with the circuit active the
receiver is less sensitive. Therefore, turn off the FTC, by setting it for 0, when its
function is not required.
To adjust the Noise Rejection level:
1. Click on the Noise Rejection line to display the Pop-up menu
2. Choose LOW or HIGH as appropriate or Off for no rejection
3. Press [ENTER] to validate.
Electrical noise, appearing on the screen as speckles, may be suppressed with the
noise rejector.
Note that some forms of interference cannot be suppressed.
The radar receiver can be tuned automatically or manually.
To adjust it from MaxSea:
1. Click on the Tune Status line to display the Pop-up menu
2. Choose receiver tuning method Automatic or Manual
3. Press [ENTER] to validate.
% 0-100 To Adjust the Tune value when working with Manual Tune Status:
1. Click on the Tune line to display the Pop-up menu
2. Adjust the range from 0 to 100% using arrows or modify it directly by entering
the desired percentage value
3. Press [ENTER] to validate.
On - Off 1. Check the Box to reject 2nd Echo signal
2. Press [ENTER] to validate.
387