MaxSea Operator Manual version 12.6 - Furuno USA

GPS on the chart
• Enter directly (or using the virtual keyboard), a distance value in the XTE zone area (by default this value is
equal to 0,5Nm)
When you will activate the route the XTE limits are drawn on the chart as it is shown in following example. note that the
XTE limits are not drawn when the route is a planning route.
When you activate the Display XTE, the Security XTE area is delimited with two dotted lines, green and red, on each
side of the active route .
For example following picture shows a XTE value equal to 0,8Nm chosen for the Leg between route points number 2 and
3.
Man Overboard
The "Man Overboard" function ( MOB ) is a necessity. It can be a useful tool when placing luminous buoys on the
water, monitoring floating objects in the water, etc.).
Select the buoy icon from the Toolbar..
The following warning applies:
Once this warning is acknowledged, the software passes immediately into Man Overboard mode:
• The MOB and the Track ON/OFF buttons are both activated in the Toolbar as it is shown with number (1)
in the following picture.
• The chart is displayed in Centered ship mode at a detailed scale (1/2 500) as it is shown in following
picture number (2).
31