MaxSea Operator Manual version 12.6 - Furuno USA

MaxSea Operator Manual version 12.6
Use corresponding drop-down menus and buttons from this toolbar to turn on/ off different functions:
1 - Switch between Depth Profile display modes (MaxSea/NavNet/Historic)
2 - switch the frequency and to toggle from HF to LF for echogram overlay (see related topic: Transmission Frequency.)
3 - To change and choose a sounder mode between Manual or different Automatic modes (see related topic: Sounder
Toolbar.)
4 - To modify gain level when manual mode is chosen (see related topic: Sounder Toolbar.)
5 - Show or Hide NavNet A scope in the depth profile window (only available if NavNet system is connected)
6 - Show or Hide NavNet echogram overlay in the depth profile window (only available if NavNet system is connected)
7 - Show or hide the depth profile outline depending on the boat movements.
8 - Show or hide the forward depth profile outline (this can be only available if your software is configured with 2D/3D
module and data are recorded in your 3D database.)
9 - To show / hide the tempeForward Looking Depth Profilerature graph in the depth profile view.
10 - Zoom in (PLUS) and Zoom Out (MINUS) the point of view
11 - Exaggeration (+) and (-) to increase or decrease the vertical scale point of view.
12 - Center the point of view on the boat position.
334
Note: selected buttons appear in full colored in red.
Changing the MaxSea Depth Profile Point View
Moving in the Depth Profile window :
Move the mouse cursor near each window border. When the cursor changes to an arrow, left-click to move
the Depth Profile graph in the direction of the arrow.
Autolock Function
Release the mouse button and few seconds after, the Autolock function will center on the depth profile in
the window when the view is outside the screen.
When user scrolls vertically and moves the depth profile outside the window, the Autolock function
becomes unactive.
The Autolock function is triggered only when the boat is displayed. It is applied on the last depth data
received.
Changing Depth Profile's display
Scale Right-click anywhere in the Depth Profile window to activate the right
mouse menu. Then choose and click an option between followings if