MaxSea Operator Manual version 12.6 - Furuno USA

Electronic Charts
To obtain information about Arcs / Seafarer and to work on it right click to call up the context menu which allows you:
• To zoom in/out and to change the scale.
• To get information by selecting Chart properties.
• To add object etc...
Related topics to:
To move the chart
To choose the scale
Note: this can take a certain time.
IMPORTANT - If you want to open a chart that is on the CD n°x, this CD must be in your CD drive, or must have
been copied to your hard drive, either the whole CD, or just the selection of charts you have access to. If not, you
will get an error message.
Adding new Chart Permits
ARCS&SeaFarerConfig software allows you to insert new chart permits.
Important: first check that the right type of permit has been selected:
• If you have ARCS skipper permit select GB.SCP window.
• If you have ARCS navigator permit select GB.NCP window.
• If you have SeaFarer chart permit select AUS.CHT window.
• If you have SeaFarer update permit select AUS.UPD window.
Go to the [Start] Windows menu point [MaxSea Utilities] and choose ARCS&SeaFarerConfig
A dialog will allow you to enter permit in two ways:
• from keyboard or from a Chart Permit file (from floppy for example).
• from a file, select from the Permit menu the Insert from File…
Insert the floppy and open the permit file (GB.SCP or GB.NCP or AUS.CHT or AUS.UPD according to your license type).
It is also possible to delete a Chart Permit by selecting Delete.
To enter a new permit from keyboard (received by phone, FAX…), select Insert from keyboard and enter the new permit
in the following window.
169