MaxSea Operator Manual version 12.6 - Furuno USA

MaxSea Operator Manual version 12.6
140
• All folders inside "My documents"
folder.
• All first level folders inside the Hard
Drives or CD drive.
• The Mapmedia CD300/01 (worldwide planning charts) is automatically installed in "My Documents" folder.
• The first time you open the software you will be shown the “Open Chart” window, from which you
can choose under a list the chart you wish to open.
• All of the charts you have installed will be shown to you. To simultaneously open several charts. To
do so, press the Ctrl key while selecting each chart you want to open.
2 - Launch again the automatic opening
• To open a specific chart region (or series of chart regions) go to [File] on the menu bar, and then
click on [Open Chart]. To stop the automatic "Chart search" click the ESC key.
• The "Open chart" window appears and shows all the charts that the software has found.
• Select a chart or several charts (to do so, press the Ctrl key while selecting the charts and click OK.
• The dialog box with the warning about the use of digitized documents appears. Click I AGREE to
agree.
3 - Manual Opening
• However, you can also open a chart by selecting [Open] from the [File] menu, like you used to do
with previous versions of software, or, for example, if you want to open charts you have already
installed on your hard drive.
• The Open file window appears and allows you to specify the location where you want to locate the
chart.
• Then pull down the pop-up menu File of type and select the type of the chart that you wish to open
( vector or rasterized). For example, if you wish to open a Mapmedia CD-ROM, select Mapmedia
from the File of type pop-up menu.
• Insert the Mapmedia CD-ROM that you wish to open. After a short while, the contents of the CD-
ROM are displayed as a list in the dialog box.
• Select the chart stored on the CD-ROM by clicking its name in the list; then click Open (or double
click the chart name in the list).
• The dialog box with the warning about the use of digitized documents appears. Click Accept if you
agree.
After it has been loaded, the Mapmedia chart is displayed in the chart window.
If you forget to enter your personal codes before starting up the software, it shows automatically the
"Mapmedia user permit" dialogue box.