MaxSea Operator Manual version 12.6 - Furuno USA

MaxSea Operator Manual version 12.6
This is where you set the XTE alarm interval and for how display will change when you arrive to a waypoint.
The "Route options" Window appears on screen and consists in a list of parameters.
First time you launch the software default values are applied but you can change all of them according to your navigation.
Following table lists all details about how to configure parameters:
Data Parameters Description and settings First time
default
value
Waypoint Label
Format
492
Click on the bar for calling up the
dialog which allows you to choose one
or several labels you want displaying
nearest a waypoint on the chart.
Check boxes depending to your
choice:
Name (personal attribute)
GPS ID (GPS attribute * )
Color (GPS attribute * )
Symbol (GPS attribute * )
Comments (personal attribute)
FID (Software attribute)
Pos (Software attribute)
Leg Label Format As above Click on the bar for calling up
the dialog which allows you to choose
one or several labels you want
displaying nearest each route legs.
Check boxes depending to your choice:
Seq Number (Software attribute)
Name (personal attribute)
All navigational attributes depending to
the actual route such as AWS, AWA,
TWS, TWA, etc... If you have chosen a
parameters between all of them and it
isn't displayed on screen, this indicates
that the value is not transmitted, they
are software parameters.
See the Leg Label Format glossary
used in each categories of route.
Name is
selected by
default and its
field is empty.
Seq
Number
Result and illustration
For example if you have chosen to
display FID and Name
In this example Seq Number and Name
are chosen and displayed on chart as it is
shown in the following picture:
Note that the Name is the same name as
you have chosen for this waypoint. The
selected leg starts from the "10" route
point to "11" route waypoint.