DOE-2 Reference Manual Version 2.1 - DOE2.com

TABLE III.2 (Cont.)Custom (a) First create a Custom Libraries of MATERIALs andLAYERS (with response factors)may be created for repeated useWei ghtingFactors witha 1 ibrarYlBDLLIB)Wei ghting Factor 1 ibraryusing LIBRARY-INPUT LOADSfor the desired space(s).(b) Specify values for SOLAR-FRACTION, in each wallinstruction, and FURNITURE-TYPE, FURN-WEIGHT,FURN-FRACTION, and WEIGHTING-FACTOR in theSPACE or SPACE-CONDITIONS instruction to create CustomWeighting Factors.(c) To run, attach BDLLIB and specify INPUT LOADS(d)3. DOE-2 Library Files.Specify the correct U-name for the WEIGHTING-FACTORkeyword in a SPACE or SPACE-CONDITIONS instructionfor those spaces with Custom Weighting Factors; for otherspaces, specify FLOOR-WEIGHT at some value greater than O.The BDL Processor of DOE-2 expects that any library file of MATERIALs,LAYERS, CONSTRUCTIONs, and/or Custom Weighting Factors available to it isnamed BDLLIB. A user-created library, if used, will have to be renamed BDLLIBand attached to the program. Described below are the requirements for thecontents of BDLLIB, depending on whether the user is running(1) Precalculated Weighting Factors with INPUT LOADS,(2) a MATERIAL, LAYERS, or CONSTRUCTION library creation run usingLIBRARY-INPUT LOADS,(3) a Custom Weighting Factor creation run with LIBRARY-INPUT LOADS, or(4) an INPUT LOADS run using a previously created Custom WeightingFactor library. The control card sequence needed to attach BDLLIBwill, of course, vary from computer system to computer system, butthe requirements for the contents of this file are set out below.The output file of all library-creation runs will be named USRLIB.* Itwill always contain whatever was in the input file BDLLIB at the beginning of*It 1S poss1ble to submit library creation runs "back to back" in one submiSSion,but this is not recommended. In this case, the output, USRLIB, ofthe first LIBRARY-INPUT LOADS deck is taken by the program to be the input fileto the next LIBRARY-INPUT LOADS deck, and the output of the second deck iscalled BDLLIB. The input and output file names will alternate in this fashion,the final output file name depending on whether an odd or even number of inputdecks was involved.II 1.147 (Revised 5/81)