DOE-2 Reference Manual Version 2.1 - DOE2.com

U-name= ZONE-CONTROL or Z-C (User Worksheet)InputRangeKeyword Abbrev. User Input Desc. Default Min. Max.LIKE = U-nameDESIGN-HEAT-T D-H-T =of Note 1 O. 80.HEAT-TEMP-SCH H-T-SCH = U-name Note 2DESIGN-COOL-T D-C-T of Note 1 O. 90.COOL-TEMP-SCH C-T-SCH = U-name Note 3BASEBOARD-CTRL B-C = code-word OUTDOOR-RESETTHERMOSTAT-TYPE T-TYPE code-word Note 4THROTTLING-RANGE T-R =of Note 5 0.1 10.1) This is a required data entry for ZONE-TYPE = CONDITIONED (see ZONEcommand). This is an optional entry for ZONE-TYPE = UNCONDITIONED or PLENUM(in this case, the default will be the value for TEMPERATURE inSPACE-CONDITIONS in the LOADS program).2) A data entry for this keyword (and for the referenced SCHEDULE instruction)is required if the zone is to be heated. WARNING: If this data entry isomitted the program will run, but NO HEATING WILL BE PROVIDED FOR THE ZONE.3) A data entry for this keyword (and for the referenced SCHEDULE instruction)is required if the zone is to be cooled. WARNING: If this data entry isomitted the program will run, but NO COOLING WILL BE PROVIDED FOR THE ZONE.4) If no data entry is made for this keyword, the program will assume aproportional thermostat (code-word ~ROPORTIONAL), except code-wordTWO-POSITION is required for correct simulation of the PTAC and HP systems.,5) 2°F for PROPORTIONAL and REVERSE-ACTION thermostats and .5°F forTWO-POSITION thermostats.IV.197 (Revised 5/81)