DOE-2 Reference Manual Version 2.1 - DOE2.com

U-name= ZONE or Z (User Worksheet)InputRangeKeyword Abbrev. User Input Desc. Default Min. Max.LIKE = U-nameZONE-TYPE Z-TYPE = code-word Note 1ZONE-AIR Z-A = U-name Note 2ZONE-CONTROL Z-C = U-name Note 2MUL TIPLIER M = number 1. I. 50.MAX-HEAT-RATE MAX-H-R (-jBtu/ hr Note 3 -1.x108 O.MAX-COOL-RATE MAX-C-R = Btu/hr Note 3 O. 1. x109BASEBOARD-RATING B-R = (-jBtu/ hr O. -1.x108 O.PANEL-LOSS-RATIO P-L-R = number O. O. 2.MIN-CFM-RATIO M-C-R = fraction Note 4 O. 1.HEATING-CAPACITY H-CAP (-j Btu/ hr Note 5 -1. x108 O.COOLING-CAPACITY C-CAP = Btu/hr Note 5 O. 1.x108COOL-SH-CAP C-S-C = Btu/hr Note 5 o. 1.x108SIZING-OPTION S-O = code-word FROM-LOADS -Plus any keywords under the ZONE-AIR and ZONE-CONTROL commands.1) If no data entry is made for this keyword, the program will assume that thezone being specified is CONDITIONED, that is heated and/or cooled.2) A data entry for this keyword is required to reference a subcommand .. 3) If no data entry is made for this keyword, the program will determine thisvalue using the methodology discussed in Sec. 0.1 of this chapter. If avalue is input for MAX-HEAT-RATE it should be input as a negative number.4) If allowed to default, the value for MIN-CFM-RATIO in SYSTEM-TERMINAL willbe used.5) Appropriate at the zone level for "zonal" systems only (UHT, UVT, TPFC,FPFC, TPIU, FPIU, HP, and PTAC). An entry may be made here in ZONE for eachzone or it may be allowed to default to the value for the same keyword inSYSTEM-EQUIPMENT. If a value is specified both here in ZONE and also inSYSTEM-EQUIPMENT, the value specified here takes precedence. Note that theinput value for HEATING-CAPACITY is negative.IV.202 (Revised 5/81)