DOE-2 Reference Manual Version 2.1 - DOE2.com

(4) Specify COOL-TEMP-SCH in the ZONE-CONTROL subcommand and anassociated SCHEDULE with hourly values of desired ZONE temperaturefor coo 1 i ng. These temperatures wi 11 be used to modu 1 ate thecooling air flow in the air duct. If the user does not specify aCOOL-TEMP-SCH for a ZONE, it will be cooled, according toCOOL-SET-T, (unless the COOLING-SCHEDULE is set to off) but therewill be no control of the cooling process.(5) Specify HEAT-TEMP-SCH in the ZONE-CONTROL subcommand and anassociated SCHEDULE with hourly values of desired ZONE temperaturefor heating. These temperatures will be used to modulate the outputof the zone heating coil. If the user does not specify aHEAT-TEMP-SCH or a ZONE, it will be cooled, according to COOL-SET-T,but not heated (except for primary air and baseboard heaters whenBASEBOARD-CTRL = OUTDOOR-RESET).(6) Specify THERMOSTAT-TYPE = PROPORTIONAL (or let it default) in theZONE-CONTROL subcommand.(7) Specify a value for REHEAT-DELTA-T in the SYSTEM-TERMINALsubcommand. This indicates to the program that zone (reheat) coilsare to be used in the ZONEs and it also indicates the maximumincrease in temperature of the supply air passing over the zonecoils. If the user does not specify a value for REHEAT-DELTA-T,there will be no reheating; if the value is specified too small,there will be inadequate reheating.(8) The desired control strategy for the system has now been specified.To complete the input, specify values for the other keywords thatare appropriate to the SYSTEM-TYPE being simulated, or allow thesekeywords to default. This exa~ple is the first strategy in TableIV.27.I V.131 (Revised 5/81)