DOE-2 Reference Manual Version 2.1 - DOE2.com

The instruction takes the formPARAMETRIC-INPUT FOR Programwhere Program is the name of the simulation program (LOADS, SYSTEMS, PLANT orECONOMICS) for which subsequent instructions are intended.Rules: 1. This instruction must have been preceded by one, and only one,corresponding INPUT instruction for the same program.Example:2. The command may be abbreviated to PAR-INPUT.3. The word FOR is optional.4. The name of the program must be one of the following: LOADS,SYSTEMS, PLANT, or ECONOMICS.5. The only instructions that may be entered between aPARAMETRIC-INPUT instruction and the next END instruction areABORT, PARAMETER, and additional TITLE instructions (beyond thoseused in the original simulation run). The only exception to thisrule is that the PLANT-ASSIGNMENT instruction may be enteredduring a PLANT parametric run.PARAMETRIC-INPUT FOR LOADS ..The above instruction indicates that subsequent input instructions containonly parametric data and are to be used to generate a new parametric set ofinput data for the LOADS Program.See also Sec. A.10 and Sec. B.6 of this chapter.3. DIAGNOSTICThe DIAGNOSTIC instruction is used to specify various options availablewhen printing instructions and diagnostic messages.The instruction takes the formDIAGNOSTIC Opt ion •.where Option is one or more code-words that specify desired DIAGNOSTIC options.Rules: 1. The DIAGNOSTIC instruction may be used as a control instruction(i .e., it need not occur between an INPUT instruction and an ENDinstruct ion).11.16 (Rev i sed 5/81)