DOE-2 Reference Manual Version 2.1 - DOE2.com

3. A parametric keyword must be defined with a PARAMETER instructionbefore its use in a keyword value assignment.4. If the TIMES feature is used with the input for a numericparametric keyword, the word TIMES must appear on the same line asthe parametric keyword.5. The value after the word TIMES may not be another parametrickeyword and it must be a number.See also Sec. A.10 and Sec. B.2 of this chapter.7 . SET-DEFAULTThe SET-DEFAULT instruction is used to assign a new default value to oneormore keywords in a particular instruction.The form of this instruction isSET-DEFAULT FOR CommandKeyword = Valuewhere Command is the name of an instruction, Keyword is the name of a keywordin that instruction, and Value is the new default value to be assigned thatkeyword.Rules: 1. Whenever a new default value (maximum of 100) is specified for thekeyword of an instruction, that value overrides the previousdefault value for that keyword, or creates a default value if thekeyword previously had none.2. The word FOR after SET-DEFAULT is required.3. The sequence Keyword = Value may be repeated if the defaultfor more than one keyword is to be changed.4. Some keywords are also subcommands (such as SYSTEM-FANS,SPACE-CONDITIONS, etc. These keywords may not be specified inSET-DEFAULT.5. Do not use SET-DEFAULT = n where n is already the default valuefor the keyword. This is because the program, in many cases,determines whether SET-DEFAULT has been used by comparing theSET-DEFAULT value with the program default value. If these arethe same, the program concludes that SET-DEFAULT has not beeninput.6. The SET-DEFAULT instruction is not applicable to SYSTEM-levelinstructions (that is, instructions that apply to more than onelONE) and PLANT instructions. This includes the PLANT-ASSIGNMENTinstruction. USing SET-DEFAULT with these instructions willproduce an error message.11.22 (Revi sed 5/81)