DOE-2 Reference Manual Version 2.1 - DOE2.com

SUPPLY-LOOUTSIDE-HIOUTSIDE-LONotes:When this instruction is specified for baseboard heatingthe user input is a heating output ratio. (See keywordBASEBOARD-SCH in the SYSTEM-CONTROL subcommand.) Theheating output is expressed as a decimal fraction of themaximum zone baseboard heating capacity (see keywordBASEBOARD-RATING in the ZONE-CONTROL subcommand).Fig. IV.16 illustrates this application.is the lower supply air set-point temperature (or outputratio) corresponding to the input value for theOUTSIDE-HI. See also the discussion for SUPPLY-HI.is the outside dry-bulb air temperature which correspondsto the input value for SUPPLY-LO (lower supply airset-point temperature).is the outside dry-bulb air temperature which correspondsto the input value for SUPPLY-HI (upper supply airset-point temperature).Note that the value for OUTSIDE-LO must not be the same asor higher than the value for OUTSIDE-HI \the program willabort and give an error message if this occurs).1. An example of a RESET-SCHEDULE is shown in the explanation for the keywordBASEBOARD-SCH (under SYSTEM-CONTROL).2. DAY-RESET-SCH cannot be nested; that is, the following is not permitted:RS-1 = RESET-SCHEDULE THRU DEC 31,(ALL)SUPPLY-HI = 120SUPPLY-LO = 70OUTSIDE-HI 70OUTSIDE-LO 0It should be specified as:DSR-1 = DAY-RESET-SCHSUPPLY-HI 120SUPPLY-LO = 70OUTSIDE-HI = 70OUTSIDE-LO = 0RS1RESET-SCHEDULE THRU DEC 31,(ALL) DSR-1IV.177 (Revised 5/81)