DOE-2 Reference Manual Version 2.1 - DOE2.com

5. The maximum number of code-numbers assigned to VARIABLE-LIST forall REPORT-BLOCKs is 60.Example:RB-1 = REPORT-BLOCKVARIABLE-TYPE = BUILDINGVARIABLE-LIST = (1,19) .•HR-1 = HOURLY-REPORTREPORT-SCHEDULE = RS-1REPORT-BLOCK = (RB-1) ..The above instructions (as used in the LOADS program) would cause thebuilding sensible heating load and building sensible cooling load to beprinted every hour for which schedule RS-l is nonzero.12. HOURLY-REPORTThe HOURLY-REPORT instruction directs the program to print the hourlyvalues of all variables specified in one or more REPORT-BLOCK instructions.These values are to be printed according to the schedule assigned to thekeyword REPORT-SCHEDULE. (A plot option also exists. See Sec. B.21 in Chap.III. )The instruct ion takes the formU-Name = HOURLY-REPORTREPORT-SCHEDULE = R-S-U-NameREPORT-BLOCK = (R-B-U-Name)where U-Name is the user-specified name for an HOURLY-REPORT instruct ion,R-S-U-Name is the U-name of a schedule instruction, and R-B-U-Name is one ormore U-names of report block instructions.Rules: 1. The entry of a U-name for this instruction is required.2. The command word may be abbreviated to H-R.3. The LIKE keyword may be used (see LIKE section).4. Report values will be printed every hour for which the hourlyvalue of the aSSigned schedule is nonzero. Note that even ifDAYLIGHT-SAVINGS = YES, summer hours will not reflect daylightsaving time. Therefore, there will be one hour differencebetween times appearing in the LOADS Summary Reports and theLOADS Hourly Reports.5. The U-name(s) assigned to the keyword REPORT-BLOCK must appearwithin parentheses, even if only one U-name is assigned.6. The keywords REPORT-BLOCK and REPORT-SCHEDULE may be abbreviatedto R-B and R-SCH, respectively.II. 32 (Revised 5/81)