Geode GXLV Processor Series Low Power Integrated x86 Solutions

More documents

Recommendations

Info

Geode GXLV Processor SeriesElectrical Specifications (Continued)6.5 DC CHARACTERISTICSAll DC parameters and current measurements in this section were measured under the operating conditions listed inTable 6-4 on page 189.6.5.1 Input/Output DC CharacteristicsTable 6-5 shows the input/output DC parameters for all the devices in the GXLV processor series.Table 6-5. DC CharacteristicsSymbol Parameter Min Typ Max Units CommentsV OL Output Low Voltage 0.4 V I OL =5mAV OH Output High Voltage 2.4 V I OH =–2mAI IInput Leakage Current for all input pinsexcept those with internal pull up/pulldowns (PU/PDs).±10 µA 0 < V IN
Electrical Specifications (Continued)6.5.2.3 Definition of System Conditions for Measuring "On" ParametersProcessor current is highly dependent two functional characteristics,DCLK (DOT clock) and SDRAM frequency. processor current parameters.measuring the typical average and absolute maximumTable 6-6 shows how these factors are controlled whenTable 6-6. System Conditions Used to Determine CPU’s Current Used During the "On" StateCPU CurrentMeasurementSystem ConditionsV CC2 V CC3 FreqDCLKSDRAMFreqTypical Average Nominal Nominal 50 MHz NominalNote 2Absolute Maximum Max Max 135 MHz MaxNote 5Notes: 1.CommentsNotes 1 and 4Notes3,4,5,7A DCLK frequency of 50 MHz is derived by setting the display mode to 800x600x8 bpp at 75 Hz, using adisplay image of vertical stripes (4-pixel wide) alternating between black and white with power managementdisabled.2. SDRAM nominal frequency represents a single value that the memory controller can be configured for,between 66 MHz and 78 MHz, based on a given core clock frequency:166 MHz (5x) / 2.5 = 66.67 MHz180 MHz (6x) / 2.5 = 72.0 MHz200 MHz (6x) / 3.0 = 66.67 MHz233 MHz (7x) / 3.0 = 77.78 MHz266 MHz (8x) / 3.5 = 76.19 MHz3. A DCLK frequency of 135 MHz is derived by setting the display mode to 1280x1024x8 bpp at 75 Hz, usinga display image of vertical stripes (1-pixel wide) alternating between black and white with power managementdisabled.4. See Table 6-4 on page 189 for nominal and maximum voltages.5. SDRAM max frequency represents the highest frequency that the memory controller can be configured,up to 100 MHz, based on a given core clock frequency:166 MHz (5x) / 2.0 = 83.3 MHz180 MHz (6x) / 2.0 = 90.0 MHz200 MHz (6x) / 2.0 = 100.0 MHz233 MHz (7x) / 2.5 = 93.3 MHz266 MHz (8x) / 3.0 = 88.9 MHz6. SDRAM speeds between 79 MHz and 100 MHz are only supported for particular types of closed systemdesigns. Therefore, absolute maximum current will not be realized in most system designs. Refer to thede-rating curve in Figure 6-3 on page 195 to calculate absolute maximum current based on the system’sparameters.7. Not all system designs will support display modes that require a DCLK of 135 MHz. Therefore, absolutemaximum current will not be realized in all system designs. Refer to the de-rating curve in Figure 6-3 onpage 195 to calculate absolute maximum current based on the system’s parameters.Geode GXLV Processor SeriesRevision 1.3 191 www.national.com
Page 4 and 5:
Geode GXLV Processor SeriesTable of
Page 6 and 7:
Page 8:
Page 12 and 13:
Geode GXLV Processor SeriesArchitec
Page 15 and 16:
Architecture Overview (Continued)Ge
Page 17 and 18:
Architecture Overview (Continued)SD
Page 19 and 20:
2.0 Signal DefinitionsThis section
Page 21 and 22:
Signal Definitions (Continued)Index
Page 23 and 24:
Signal Definitions (Continued)PinNo
Page 25 and 26:
Signal Definitions (Continued)Table
Page 27 and 28:
Signal Definitions (Continued)PinNo
Page 29 and 30:
Signal Definitions (Continued)Table
Page 31 and 32:
Signal Definitions (Continued)2.2 S
Page 33 and 34:
Signal Definitions (Continued)2.2.2
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
3.0 Processor ProgrammingThis secti
Page 43 and 44:
Processor Programming (Continued)3.
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Processor Programming (Continued)Bi
Page 51 and 52:
Processor Programming (Continued)Ta
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Processor Programming (Continued)Th
Page 63 and 64:
Page 65 and 66:
Processor Programming (Continued)Ad
Page 67 and 68:
Page 69 and 70:
Processor Programming (Continued)Se
Page 71 and 72:
Page 73 and 74:
Processor Programming (Continued)TY
Page 75 and 76:
Processor Programming (Continued)Ta
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Processor Programming (Continued)Wh
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Integrated Functions (Continued)4.1
Page 99 and 100:
Page 101 and 102:
Integrated Functions (Continued)Mne
Page 103 and 104:
Page 105 and 106:
Integrated Functions (Continued)Bit
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Integrated Functions (Continued)ACT
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Integrated Functions (Continued)Tab
Page 121 and 122:
Integrated Functions (Continued)SDR
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Integrated Functions (Continued).Re
Page 139 and 140: Integrated Functions (Continued)640
Page 141 and 142: Integrated Functions (Continued)4.5
Page 143 and 144: Integrated Functions (Continued)GX_
Page 145 and 146: Integrated Functions (Continued)11:
Page 147 and 148: Integrated Functions (Continued)Tab
Page 149 and 150: Integrated Functions (Continued)9:0
Page 151 and 152: Integrated Functions (Continued)Bit
Page 163 and 164: Integrated Functions (Continued)Tab
Page 177 and 178: Power Management (Continued)CPU Sus
Page 179 and 180: Power Management (Continued)5.2.2 I
Page 181 and 182: Power Management (Continued)5.3 POW
Page 183 and 184: Power Management (Continued)Table 5
Page 185 and 186: Electrical Specifications (Continue
Page 189: Electrical Specifications (Continue
Page 207 and 208: 7.0 Instruction SetThis section sum
Page 209 and 210: Instruction Set (Continued)7.1.2.3
Page 217 and 218: Instruction Set (Continued)Table 7-
Page 219 and 220: Instruction Set (Continued)Instruct
Page 221 and 222: Instruction Set (Continued)JMP Unco
Page 233 and 234: Instruction Set (Continued)7.5 MMX
Page 235 and 236: Instruction Set (Continued)PCMPEQB
Page 237 and 238: Instruction Set (Continued)PUNPCKHW
Page 241 and 242:
Package Specifications (Continued)C
Page 243 and 244:
Package Specifications (Continued)8
Page 245 and 246:
Package Specifications (Continued)S
Page 247:
Geode GXLV Processor Series Low Pow
show all

Geode GXLV Processor Series Low Power Integrated x86 Solutions

Create successful ePaper yourself

Delete template?

Save as template?