Geode GXLV Processor Series Low Power Integrated x86 Solutions

More documents

Recommendations

Info

Geode GXLV Processor SeriesProcessor Programming (Continued)Table 3-22. Descriptors Bit DefinitionsBitMemoryOffset Name Description31:24 +4 BASE Segment Base Address: Three fields which collectively define the base location for the segment in7:0 +44 GB physical address space.31:16 +019:16 +4 LIMIT Segment Limit: Two fields that define the size of the segment based on the Segment Limit15:0 +0Granularity Bit.If G = 1: Limit value interpreted in units of 4 KB.If G = 0: Limit value is interpreted in bytes.23 +4 G Segment Limit Granularity Bit: Defines LIMIT multiplier.If G = 1: Limit value interpreted in units of 4 KB. Segment size ranges from 4 KB to 4 GB.If G = 0: Limit value is interpreted in bytes. Segment size ranges from 1 byte to 1 MB.22 +4 D Default Length for Operands and Effective Addresses:If D = 1: Code segment = 32-bit length for operands and effective addresses.If D = 0: Code segment = 16-bit length for operands and effective addresses.If D = 1: Data segment = Pushes, calls and pop instructions use 32-bit ESP register.If D = 0: Data segment = Stack operations use 16-bit SP register.20 +4 AVL Segment Available: This field is available for use by system software.15 +4 P Segment Present:If = 1: Segment is memory segment allocated.If = 0: The BASE and LIMIT fields become available for use by the system. Also, If = 0, a segmentnot-presentexception generated when selector for the descriptor is loaded into a segment registerallowing virtual memory management.14:13 +4 DPL Descriptor Privilege Level:If = 00: Highest privilege levelIf = 11: Lowest privilege level12 +4 S Descriptor Type:If = 1: Code or data segmentIf = 0: System segment11:8 +4 TYPE Segment Type: Refer to Table 3-23 for TYPE bit definitions.Bit 11 = ExecutableBit 10 = Conforming if Bit 12 = 1Bit 10 = Expand Down if Bit 12 = 0Bit 9 = Readable, if Bit 12 = 1Bit 9 = Writable, if Bit 12 = 0Bit 8 = Accessedwww.national.com 72 Revision 1.3
Processor Programming (Continued)TYPEBits [11:8]Table 3-23. Application and System Segment Descriptors TYPE Bit DefinitionsSystem Segment and Gate TypesBit 12 = 0Application Segment TypesBit 12 = 1Num SEWA TYPE (Data Segments)0 0000 Reserved Data Read-Only1 0001 Available 16-Bit TSS Data Read-Only, accessed2 0010 LDT Data Read/Write3 0011 Busy 16-Bit TSS Data Read/Write accessed4 0100 16-Bit Call Gate Data Read-Only, expand down5 0101 Task Gate Data Read-Only, expand down, accessed6 0110 16-Bit Interrupt Gate Data Read/Write, expand down7 0111 16-Bit Trap Gate Data Read/Write, expand down, accessedNum SCRA TYPE (Code Segments)8 1000 Reserved Code Execute-Only9 1001 Available 32-Bit TSS Code Execute-Only, accessedA 1010 Reserved Code Execute/ReadB 1011 Busy 32-Bit TSS Code Execute/Read, accessedC 1100 32-Bit Call Gate Code Execute/Read, conformingD 1101 Reserved Code Execute/Read, conforming, accessedE 1110 32-Bit Interrupt Gate Code Execute/Read-Only, conformingF 1111 32-Bit Trap Gate Code Execute/Read-Only, conforming accessedSEWA/SCRA:S = Code Segment (not Data Segment)E = Expand DownW = Write EnableA = AccessedC = Conforming Code SegmentR = Read EnableGeode GXLV Processor SeriesRevision 1.3 73 www.national.com
Page 4 and 5:
Geode GXLV Processor SeriesTable of
Page 6 and 7:
Page 8:
Page 12 and 13:
Geode GXLV Processor SeriesArchitec
Page 15 and 16:
Architecture Overview (Continued)Ge
Page 17 and 18:
Architecture Overview (Continued)SD
Page 19 and 20:
2.0 Signal DefinitionsThis section
Page 21 and 22: Signal Definitions (Continued)Index
Page 23 and 24: Signal Definitions (Continued)PinNo
Page 25 and 26: Signal Definitions (Continued)Table
Page 27 and 28: Signal Definitions (Continued)PinNo
Page 29 and 30: Signal Definitions (Continued)Table
Page 31 and 32: Signal Definitions (Continued)2.2 S
Page 33 and 34: Signal Definitions (Continued)2.2.2
Page 41 and 42: 3.0 Processor ProgrammingThis secti
Page 43 and 44: Processor Programming (Continued)3.
Page 49 and 50: Processor Programming (Continued)Bi
Page 51 and 52: Processor Programming (Continued)Ta
Page 61 and 62: Processor Programming (Continued)Th
Page 65 and 66: Processor Programming (Continued)Ad
Page 69 and 70: Processor Programming (Continued)Se
Page 71: Processor Programming (Continued)3.
Page 75 and 76: Processor Programming (Continued)Ta
Page 89 and 90: Processor Programming (Continued)Wh
Page 97 and 98: Integrated Functions (Continued)4.1
Page 101 and 102: Integrated Functions (Continued)Mne
Page 105 and 106: Integrated Functions (Continued)Bit
Page 111 and 112: Integrated Functions (Continued)ACT
Page 119 and 120: Integrated Functions (Continued)Tab
Page 121 and 122: Integrated Functions (Continued)SDR
Page 123 and 124:
Integrated Functions (Continued)4.3
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Integrated Functions (Continued)Bit
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Integrated Functions (Continued).Re
Page 139 and 140:
Integrated Functions (Continued)640
Page 141 and 142:
Page 143 and 144:
Integrated Functions (Continued)GX_
Page 145 and 146:
Integrated Functions (Continued)11:
Page 147 and 148:
Integrated Functions (Continued)Tab
Page 149 and 150:
Integrated Functions (Continued)9:0
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Integrated Functions (Continued)Tab
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Power Management (Continued)CPU Sus
Page 179 and 180:
Power Management (Continued)5.2.2 I
Page 181 and 182:
Power Management (Continued)5.3 POW
Page 183 and 184:
Power Management (Continued)Table 5
Page 185 and 186:
Electrical Specifications (Continue
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
7.0 Instruction SetThis section sum
Page 209 and 210:
Instruction Set (Continued)7.1.2.3
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Instruction Set (Continued)Table 7-
Page 219 and 220:
Instruction Set (Continued)Instruct
Page 221 and 222:
Instruction Set (Continued)JMP Unco
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Instruction Set (Continued)7.5 MMX
Page 235 and 236:
Instruction Set (Continued)PCMPEQB
Page 237 and 238:
Instruction Set (Continued)PUNPCKHW
Page 239 and 240:
Page 241 and 242:
Package Specifications (Continued)C
Page 243 and 244:
Package Specifications (Continued)8
Page 245 and 246:
Package Specifications (Continued)S
Page 247:
Geode GXLV Processor Series Low Pow
show all

Geode GXLV Processor Series Low Power Integrated x86 Solutions

Create successful ePaper yourself

Delete template?

Save as template?