Apple MainStage 3 Instruments - MainStage 3 Instruments

Create a modulation routing that includes a via source
1 Choose the target parameter you want to modulate from the Dest pop-up menu.
Click here to choose a
modulation destination.
Click here to choose a
modulation source.
2 Choose a modulation source from the Src pop-up menu.
3 Choose the modulation source that you want to use for control of modulation intensity from the
via pop-up menu.
4 Vertically drag the upper intensity slider to set the maximum modulation intensity.
5 Vertically drag the lower intensity slider to set the minimum modulation intensity.
Move the entire via range
mm
Vertically drag the area between the two intensity slider halves (the range).
Both arrowheads move simultaneously.
Tip: If this area is too small to drag, just drag an unused section of the intensity slider to move
the area.
Chapter 9 EXS24 mkII 182