Apple MainStage 3 Instruments - MainStage 3 Instruments
Apple MainStage 3 Instruments - MainStage 3 Instruments
Apple MainStage 3 Instruments - MainStage 3 Instruments
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Set up Vector Envelope loops<br />
The Vector Envelope can run in one-shot mode, as long as the note is sustained; it can be set to<br />
repeat a specific number of times or it can repeat indefinitely, much like an LFO modulation. You<br />
achieve repetitions by using the loop functions.<br />
Although the loop parameters seem similar to the loop parameters available for samples, there<br />
are significant differences between them. The Vector Envelope only supplies control signals that<br />
are used to move the pointer positions of the Triangle and Planar Pad. The audio output of the<br />
ES2 is not looped in any way.<br />
Any point can be declared the Loop point. Provided that the note is held for a suitable length of<br />
time, portions of the envelope can be repeated, or looped.<br />
The looped area spans the time between the Sustain point and the Loop point. In between these<br />
points you can define several points that describe pointer movements in the Triangle and the<br />
Planar Pad.<br />
Define a point as the Loop point<br />
mm<br />
Click in the turquoise strip below the chosen point.<br />
A Loop point is indicated by an L in the strip below.<br />
Set a Vector Envelope Loop mode<br />
mm<br />
Choose one of the following Vector Envelope Loop modes: Off, Forward, Backward, and Alternate.<br />
••<br />
Off: When Loop mode is set to Off, the Vector Envelope runs in one-shot mode from beginning<br />
to end, if the note is held long enough to complete all envelope phases. The other loop<br />
parameters are disabled.<br />
••<br />
Forward: When Loop mode is set to Forward, the Vector Envelope runs from the beginning<br />
to the Sustain point, and then begins to periodically repeat the section between the Sustain<br />
point and the Loop point in a forward direction.<br />
••<br />
Backward: When Loop mode is set to Backward, the Vector Envelope runs from the beginning<br />
to the Sustain point, and then begins to periodically repeat the section between the Sustain<br />
point and the Loop point in a backward direction.<br />
••<br />
Alternate: When Loop mode is set to Alternate, the Vector Envelope runs from the beginning<br />
to the Sustain point and then periodically switches to the Loop point, then back to the Sustain<br />
point, alternating between backward and forward directions.<br />
Click here to choose a<br />
Loop mode.<br />
Chapter 3 ES2 73