Apple MainStage 3 Instruments - MainStage 3 Instruments

••
Resonance knob (morphable): Rotate to set the filter resonance value.
••
In highpass and lowpass modes, Resonance emphasizes the portions of the signal that
surround the center frequency.
••
In Peak, Bandpass, and Notch modes, Resonance controls the width of the band that
surrounds the center frequency.
••
Key (tracking) knob: Rotate to determine how cutoff frequency responds to key position. The
farther up or down the keyboard you play, the more bright or mellow the sound becomes.
Technically speaking, the cutoff frequency is modulated by the keyboard position. A value of
0.0 disables key tracking. A value of 1.0 makes the cutoff frequency follow the fundamental of
the note across the entire keyboard range. Play an octave higher and the cutoff frequency also
changes by an octave.
••
Velo Sens knob: Rotate to determine how cutoff frequency responds to incoming note
velocities. The harder you strike the keyboard, the higher the cutoff frequency—and, generally,
the brightness of the sound—becomes. A value of 0.0 disables velocity sensitivity. A value of
1.0 results in maximum velocity sensitivity.
Sculpture delay effect parameters
Sculpture delay effect overview
This is a (project) tempo-syncable stereo delay. It can also run freely (unsynchronized). The Delay
section features all the general delay parameters you’d expect from a delay plus the Groove
(delay timing) Pad.
Delay on/off button
Wet Level knob
Groove pad
LoCut/HiCut sliders
Xfeed knob
Feedback knob
Output Width slider
Sync button
Input Balance
slider
Delay Time slider
Delay effect parameters
••
Delay On/Off button: Turns the Delay effect on or off.
••
Wet Level knob: Rotate to set the Delay output level.
••
Feedback knob: Rotate to set the amount of delay signal that is routed back from the
delay unit output channels to the delay unit input channels. Negative values result in
phase-inverted feedback.
••
Xfeed (Crossfeed) knob: Rotate to set the amount of delay signal that is fed from the delay unit’s
left output channel to the right input channel and vice versa. Negative values result in phaseinverted
feedback of the crossfed signal.
••
LoCut slider: Determines the cutoff frequency of the highpass filter at the delay line output/
feedback loop.
Chapter 13 Sculpture 258