Apple MainStage 3 Instruments - MainStage 3 Instruments
Apple MainStage 3 Instruments - MainStage 3 Instruments
Apple MainStage 3 Instruments - MainStage 3 Instruments
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Set the Vector Envelope Loop Rate<br />
Do one of the following:<br />
mm<br />
Drag the green indicator in the center of the Loop Rate bar to the left or right.<br />
mm<br />
Drag vertically in the value field “as set” (shown in the figure below).<br />
The Vector Envelope loop can cycle at a defined speed. It can also be synchronized with the host<br />
application tempo.<br />
••<br />
As set: If you switch the Loop Rate to “as set,” the loop cycle length equals the sum of the times<br />
between the sustain and Loop points. Click the field labeled “as set” below the Rate slider to<br />
select it.<br />
••<br />
Rhythmic: If you set the Loop Rate to one of the rhythmic values (sync) by dragging the Loop<br />
Rate indicator toward the left half of the slider, the loop rate follows the project tempo. You<br />
can choose from 32 bars up to a 64th triplet note value.<br />
••<br />
Free: You can also set a free Loop Rate by dragging the Loop Rate indicator toward the right<br />
half of the slider (free). The value indicates the number of cycles per second.<br />
Note: If Loop Rate is not switched to “as set,” and Loop mode (Forward, Backward, or Alternate)<br />
is active, the times of points between the Loop and Sustain points and the Loop Smooth value<br />
are shown as a percentage of the loop duration, rather than in milliseconds.<br />
Make smooth Vector Envelope loop transitions<br />
mm<br />
When Loop mode is set to Forward or Backward, there is a transition from the Sustain<br />
point to the Loop point. Turn on Loop Smooth to even out this transition, avoiding abrupt<br />
position changes.<br />
••<br />
If the Loop Rate parameter is set to Sync or Free, the loop-smoothing time is displayed as a<br />
percentage of the loop cycle duration.<br />
••<br />
If the Loop Rate parameter is “as set,” the loop-smoothing time is displayed in milliseconds<br />
(ms).<br />
Specify a Vector Envelope loop count<br />
mm<br />
The Vector Envelope loop cycle can be repeated a specified number of times. Following the<br />
defined number of repetitions, the Vector Envelope runs from the Sustain point onward. Possible<br />
values are 1 to 10 and “infinite.”<br />
Chapter 3 ES2 74