E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Performing Manual Control Section 4-13
amad on
6. Use the U Key to set the parameter to ON. (The default is ON.)
Initial Setting Level 7. Press the O Key for at least one second to move from the advanced
Input Type
function setting level to the initial setting level.
in-t 5
8. Press the O Key for at least one second to move from the initial setting
level to the operation level.
Operation Level
a-m
9. Select the Auto/Manual Switch parameter by pressing the M Key.
Auto/Manual
Switch
Manual Control Level 10. Press the O Key for at least three seconds to move from the operation
C
PV/MV
25.0
0.0
level to the manual control level.
C
25.0
50.0
11. Press the U or D Key to set the manual MV. (In this example, the MV is
set to 500%.)
Note The manual MV setting must be saved (see page 14), but values
changed with Key operations are reflected in the control output
immediately.
Operation Level 12. Press the O Key for at least one second to move from the manual control
C
alm
level to the operation level.
25.0
100.0
▲
▲
Operating Procedure In this example, A-M (Auto/Manual) is set for the PF Setting parameter
(E5AN/EN-H only).
Operation Level
C
25.0
100.0
Initial Setting Level 1. Press the O Key for at least three seconds to move from the operation
Input Type
level to the initial setting level.
in-t 5
cntl
pid
▲
▲
alm
2. Select the PID ON/OFF parameter by pressing the U Key. (The default
is PID.)
Initial Setting Level 3. Select the Move to Advanced Function Setting Level parameter by press-
amov 0
Move to Advanced
Function
Setting Level
ing the M Key. (For details on moving between levels, refer to 4-8 Moving
to the Advanced Function Setting Level.)
123