E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Bank Setting Level Section 5-5
Setting
See
214
During temperature input, the decimal point position is set automatically
according to the current sensor, and during analog input it depends on the
Decimal Point parameter setting.
Setting range Unit Default
−19999 to 32400 EU 0.0
■ Related Parameters
Input type: Page 224
Scaling upper limit, Scaling lower limit, Decimal point: Page 226
Alarm 3 type (initial setting level): Page 234
Standby sequence reset: Page 244
Auxiliary output * open in alarm: Page 245
Alarm 3 hysteresis: Page 233
Alarm 3 latch (advanced function level): Page 250
*.a3h Bank * Alarm Value Upper Limit 3 Alarm 3 must be assigned.
*.a3l
Function
Setting
See
Bank * Alarm Value Lower Limit 3
(*: 0 to 7)
The alarm 3 type must be set to
"upper and lower limit alarm,"
"upper and lower limit range alarm,"
or "upper and lower limit alarm with
standby sequence."
These parameters set the alarm value upper and lower limits individually for
each bank when the mode for setting the upper and lower limits is selected for
the Alarm 3 Type parameter (initial setting level).
These parameters set the upper and lower limits of alarm 3 for banks 0 to
7.
During temperature input, the decimal point position is set automatically
according to the current sensor, and during analog input it depends on the
Decimal Point parameter setting.
Setting range Unit Default
−19999 to 32400 EU 0.0
■ Related Parameters
Input type: Page 224
Scaling upper limit, Scaling lower limit, Decimal point: Page 226
Alarm 3 type (initial setting level): Page 234
Standby sequence reset: Page 244
Auxiliary output * open in alarm: Page 245
Alarm 3 hysteresis: Page 233
Alarm 3 latch (advanced function level): Page 250