E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Using the Transfer Output Section 4-14
Output current (mA)
20
4
0
10
Transfer output
lower limit
90 100
Transfer output
upper limit
MV (%)
(The above graph is for when the linear current output is set to 4 to 20 mA.)
Operating Procedure The following procedure sets the transfer output for an SP range of −50 to
200.
Operation Level
C
25.0
100.0
Initial Setting Level 1. Press the O Key for at least three seconds to move from the operation
Input Type
level to the initial setting level.
in-t 5
Initial Setting Level 2. Select the Transfer Output Type parameter by pressing the M Key.
tr-t
off
tr-t sp
PV/SP
Transfer Output
Type
3. Press the U Key to select sp (set point).
Initial Setting Level 4. Select the Transfer Output Upper Limit parameter by pressing the M Key.
C
Transfer Output
tr-h Upper Limit
1300.0
C
tr-h
200.0
5. Use the D Key to set the parameter to 200.0. The default is 1300.0.
Initial Setting Level 6. Select the Transfer Output Lower Limit parameter by pressing the M Key.
C
Transfer Output
tr-l Lower Limit
-200.0
127