E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Manual Control Level Section 5-8
5-8 Manual Control Level
The manipulated variable can be set in manual mode while the PV/MV parameter
is displayed.
The final MV used in automatic mode will be used as the initial manual MV
when moving from automatic mode to manual mode. In manual mode, the
change value will be saved immediately and reflected in the actual MV.
Power ON
Operation
Level
Press the O Key for
at least 1 s.
PID Setting
Level
Adjustment
Level
Bank Setting
Level
Press the PF Key for
at least 1 s or the O
a-m Press the O Key for at
least 1 s; display will flash.
Press the PF Key
for at least 1 s. (See note.)
Key for at least 1 s.
Press the O Key for
(See note.)
at least 3 s.
Manual Control Level
Note: When the PF Setting parameter is
set to A-M for a Controller that has a
PF Key (E5AN/EN-H).
To move from the operation level to the manual control level, press the O Key
for at least three seconds with the Auto/Manual Switch parameter displayed.
In addition, this operation can be performed using the PF Key by setting the
PF Key parameter (advanced function setting level) to A-M (Auto/Manual). For
details on the setting method, refer to 4-13 Performing Manual Control.
This setting cannot be made during ON/OFF operation.
The MANU indicator will light during manual control.
It is not possible to move to any displays except for the PV/MV parameter
during manual operation.
To return to the operation level, press the O Key or the PF Key in the
manual control level for at least one second.
PV/MV (Manual MV)
With No. 3 Display
Function C
25.0
100.0
50.0
The manual control level display appears as shown below.
MANU MANU
25.0
50.0
PV/SP/Manual MV PV/Manual MV
C
Note: When the PV/SP Display Screen
Selection parameter is 0.
Without No. 3 Display
C
25.0
MANU 50.0
PV/Manual MV
221