E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Initial Setting Level Section 5-9
tr-h Transfer Output Upper Limit A transfer output or linear voltage
output must be supported.
tr-l Transfer Output Lower Limit
Function
Setting
See
236
Transfer output
type
This parameter sets the upper and lower limit values of transfer outputs.
Set point (See
note 1.)
Set point during
SP ramp
SP lower limit to SP upper limit
PV Temperature Input setting range lower limit
to input setting range upper
limit
Analog Analog scaling lower limit to
analog scaling upper limit
MV monitor
(heating) (See
note 2.)
MV monitor
(cooling) (See
note 3.)
Valve opening
(See note 4.)
Note (1) If the set point is selected, the remote SP will be output as long as the
Remote SP Mode is selected in the SP Mode parameter.
(2) This setting will be ignored for position-proportional model.
(3) This setting will be ignored for standard control or position-proportional
control.
(4) This parameter will be displayed only when the is a potentiometer input
for a position-proportional model.
■ Related Parameter
Transfer output type (initial setting level): Page 235
The Transfer Output Type parameter
must not be set to OFF.
Setting range Default Unit
Transfer
output lower
limit
Transfer
output upper
limit
SP lower limit to SP upper limit SP lower limit SP upper limit EU
Input setting
range lower
limit
Scaling lower
limit
Input setting
range upper
limit
Scaling upper
limit
Standard −5.0 to 105.0 0.0 100.0 %
Heating/
cooling
0.0 to 105.0
0.0 to 105.0
Position-proportional
−10.0 to 110.0
o1-t Linear Current Output
The E5CN-H must be used, and the
control output must be a current output.
This parameter selects the output type for linear current outputs.
When control output 1 or control output 2 is a current output, select either
4 to 20 mA or 0 to 20 mA as the output type.