E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Adjustment Level Section 5-4
of-r Manual Reset Value
Function
Setting
See
202
This parameter sets the required manipulated variable to remove offset
during stabilization of P or PD control.
Setting range Unit Default
0.0 to 100.0 % 50.0
■ Related Parameters
PID * integral time (PID setting level): Page 217
PID ON/OFF (initial setting level): Page 228
The control must be standard control
and 2-PID control.
The Integral Time parameter for PID
sets 1 to 8 must be set to 0.
hys Hysteresis (Heating) The control must be ON/OFF control.
For the Hysteresis (Cooling) parame-
chys Hysteresis (Cooling)
Function
Setting
See
Parameter
name
Hysteresis
(Heating)
Hysteresis
(Cooling)
ter, the control must be heating/cooling
control.
This parameter sets the hysteresis for ensuring stable operation at the ON/
OFF switching point.
For standard control, use the Hysteresis (Heating) parameter. The Hysteresis
(Cooling) parameter cannot be used.
For heating/cooling control, the hysteresis can be set independently for
heating/cooling. The Hysteresis (Heating) parameter is used for the heating
side, and the Hysteresis (Cooling) parameter is used for the cooling
side.
Model Setting range Unit Default
Temperature input 0.1 to 3240.00 °C or °F 1.0
Analog Input 0.01 to 99.99 %FS 0.10
Temperature input 0.1 to 3240.00 °C or °F 1.0
Analog Input 0.01 o 99.99 %FS 0.10
■ Related Parameters
PID ON/OFF, Standard or heating/cooling (initial setting level): Page 228