E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Wiring Terminals Section 2-2
Take countermeasures such as installing a surge absorber. As an additional
safety measure, provide error detection in the control loop. (Use the
Loop Burnout Alarm (LBA) and HS alarm that are provided for the E5@N-
H.)
Varistor
SSR output
Select a surge absorber that satisfies the following conditions.
Voltage used Varistor voltage Surge resistance
100 to 120 VAC 240 to 270 V 1,000 A min.
200 to 240 VAC 440 to 470 V
Control Output 2 Outputs are sent from terminals 11, 12, 14, and 15 with the E5CN-H, and
from pins 5 and 6 with the E5AN/EN-H. The following diagrams show the
available outputs and their internal equalizing circuits.
Relay
The following table shows the specifications for each output type.
E5CN-H
3
4
E5AN/EN-H
Varistor
+v
+v
+
11
L or
+
14
L
GND 12
−
GND 15
−
Voltage (for driving SSR) Voltage (for driving SSR)
5
6
E5CN-H
SSR
5
6
+v
+
5
L
GND 6
−
E53-Q4 (PNP)
E53-QN (PNP)
Load
~
+v
5
6
+
L
−
V
+
5
L
GND
6
−
E53-Q3 (NPN) E53-V34N
E53-V35N
E5AN/EN-H
Output type Specifications
Voltage (for driving
SSR)
+
5
mA L
6
−
E53-C3N
E53-C3DN
PNP type, 12 VDC ±15%, 21 mA (with short-circuit protection)
Output type Specifications
SSR 75 to 250 VAC 1 A (See note.)
Relay (Position- 250 VAC 1 A (including inrush current)
proportionalmodels) Note The SSR output (control output 1 or control output 2) ratings are as
follows:
Rated load voltage: 75 to 250 VAC
Rated load current: 1 A (resistance load)
Use the load current within the derating curve.
33