E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Advanced Function Setting Level Section 5-10
252
Setting range Default
on: Enabled, off: Disabled off
cjc Cold Junction Compensation Method Input type must be thermocouple.
Function
Setting
See
This parameter specifies whether cold junction compensation is to be performed
internally by the Controller or to be performed externally when the
input type setting is 5 to 23.
The cold junction compensation external setting is enabled when the temperature
difference is measured using two thermocouples.
Setting range Default
on: Internally, off: Externally on
■ Related Parameters
Input type (initial setting level): Page 224
rlrv MB Command Logic Switching
Function
Setting
See
This parameter switches the logic of the MB command (communications
writing switch) for the SYSWAY communications protocol
The MB command (communications writing switch) is the equivalent of
the MB command (remote/local switch) of the E5@J.
The setting indicated by the shaded cell indicates the default (same logic
as E5@J).
(Terms in parentheses () are the terms used on the E5@J.)
■ Related Parameters
Communications writing (adjustment level): Page 193
Protocol setting (communications setting level): Page 281
Communications must be supported.
CompoWay/F must be selected as
the protocol.
Set
Text data of MB command
value
0000 0001
OFF Communications writing enabled Communications writing disabled
(remote mode selection)
(local mode selection)
ON Communications writing disabled Communications writing enabled
(local mode selection)
(remote mode selection)