E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Operation Level Section 5-3
bank Bank No.
Function
Operation
See
rsp Remote SP Monitor
Function
Monitor
See
The Bank Numbers Used parameter
must be set to 0.
This parameter is used to select the bank. The SP, PID set number, SP
ramp set value, alarm value, soak time, and wait band are set in bank setting
level for each bank to be used, and then operation is switched
between the banks using bank specifications (with event inputs, key operations,
or communications).
With this parameter, the bank is specified by using key operations.
Use the U and D Keys to specify the bank number.
The default is for the current bank number to be displayed.
■ Related Parameters
Bank numbers used (advanced function setting level): Page 237
The ST parameter must be set to
OFF.
The Remote SP Enable parameter
must be set to ON.
The SP Mode parameter must be set
to LSP.
This parameter monitors the remote SP while in Local SP Mode.
While in Remote SP Mode, the remote SP can be monitored on the No.
2 display of the PV/SP Screen.
Monitor range Unit
Remote SP lower limit to remote EU
SP upper limit
There are restrictions on the SP
limits.
■ Related Parameters
Process value/Set point (operation level): Page 177
SP mode (adjustment level): Page 193
Remote SP upper limit, Remote SP lower limit (advanced function setting
level): Page 267
Remote SP enable (advanced function setting level): Page 266
179