E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Adjustment Level Section 5-4
mv-s MV at Stop
Function
Setting
See
mv-e MV at PV Error
Function
Setting
See
204
This parameter sets the MV to use when the RUN/STOP status changes
from RUN to STOP.
■ Related Parameters
The control must be set to 2-PID
control.
The MV at Stop and Error Addition
parameter must be ON.
Setting range Unit Default
Standard control: −5.0 to 105.0
Heating/cooling control: −105.0 to 105.0
Position-proportional control (close, with the
Direct Setting of Position Proportional MV
parameter ON): −5.0 to 105.0
% 0.0
Position-proportional control (floating or
with the Direct Setting of Positional Proportional
MV parameter OFF): CLOS, HOLD,
OPEN
None HOLD
RUN/STOP (operation level): Page 185
MV at stop and error addition (advanced function setting level): Page 256
The control must be set to 2-PID
control.
The MV at Stop and Error Addition
parameter must be ON.
This parameter sets the MV to use when an input error occurs.
Setting range Unit Default
Standard control: −5.0 to 105.0
Heating/cooling control: −105.0 to 105.0
Position-proportional control (close, with the
Direct Setting of Position Proportional MV
parameter ON): −5.0 to 105.0
% 0.0
Position-proportional control (floating or
with the Direct Setting of Positional Proportional
MV parameter OFF): CLOS, HOLD,
OPEN
None HOLD
■ Related Parameters
MV at stop and error addition (advanced function setting level): Page 256