E5CNH E5AN-H E5EN-H Digital Controllers User's Manual - OMRON

Operation Level Section 5-3
Function
Monitor
See
Function
Monitor
Process Value
The Additional PV Display parameter
must be set to ON.
The process value is displayed on the No. 1 display, and nothing is displayed
on the No. 2 and No. 3 (E5AN/EN-H only) displays.
Monitor range Unit
Process value Temperature: According to indication range for
each sensor.
Analog: Scaling lower limit −5% FS to Scaling
upper limit +5% FS (Refer to page 335.)
EU
During temperature input, the decimal point position depends on the currently
selected sensor, and during analog input it depends on the Decimal Point
parameter setting.
■ Related Parameters
Input type: Page 224, Set point upper limit, Set point lower limit: Page 227 (initial
setting level)
Process Value/Set Point (Display 1)
Process Value/Set Point (Display 2)
(The Process Value/Set Point (Display
2) parameter is supported for
the E5AN-H and E5EN-H only.)
The process value is displayed on the No. 1 display, and the set point is displayed
on the No. 2 display.
Monitor range Unit
Process value Temperature: According to indication range for
each sensor.
Analog: Scaling lower limit −5% FS to Scaling
upper limit +5% FS (Refer to page 335.)
EU
Setting range Unit
Set point SP lower limit to SP upper limit EU
During temperature input, the decimal point position depends on the currently
selected sensor, and during analog input it depends on the Decimal Point
parameter setting.
No. 3 Display (E5AN/EN-H)
The following table shows the contents of the No. 3 display, according to the
setting of the PV/SP Display Screen Selection parameter.
Set value Display contents
0 Only the PV and SP are displayed. (The No. 3 display is not
shown.)
1 PV/SP/Bank No. and PV/SP/MV are displayed in order.
177