SV-iS7 User Manual - Inverter Drive Supermarket

7.1.8 Run immediately with power On: Power-on Run
Chapter 7 Basic Functions
Group Code No. Function Display Setting Display Setting Range Unit
DRV 06 Cmd Source - 1 ~ 2 - -
ADV 10 Power-on Run 1 --- yes --- No/Yes -
With power supplied to the inverter and the terminal block operating command being ON, the inverter starts operating.
This is effective only when the DRV Group 06 command source is set at 1 (Fx/Rx-1) or 2 (Fx/Rx-2). At this time, if load
(Fan load) is on the status of Free-Run, Trip may be occurred while operating. Change the bit 4 to 1 at CON-71 Speed
Search and it makes the inverter can start with Speed Search. If not, inverter will be accelerating normal V/F pattern
without Speed Search.
If this function is not selected, operation resumes after the operating commands is turned OFF and ON again.
Caution
Be careful with this function, which causes the motor to rotate as soon as the power is
supplied.
7.1.9 Restarts by reset after trip: RST Restart
Group Code No. Function Display Setting Display default Setting Range Unit
DRV 06 Cmd Source - FX/RX-1
or FX/RX-2
FX/RX-1 1~2 -
08 RST Restart 1 -- yes -- 0:No No(1)/Yes(1) -
PRT 09 Retry Number 1 0 0~10 -
10 Retry Delay 1.0 1.0 0~60.0 sec
The inverter resumes if the terminal block operating command is ON when it is reset after a trip. Inverter cut the output
when inverter trip is occurred and motor run to Free-Run. At this time, inverter trip can be occurred. Change the bit 2
to 1 at CON-71 Speed Search and Inverter will be start with Speed Search when trip is released. If not, inverter will be
accelerating normal V/F pattern without Speed Search.
If this function is not used, operation resumes when the operating command is turned OFF and then ON again after
resetting.
Power
Frequency
Operating
command
When ADV-10=0 When ADV-10=1
7-15