SV-iS7 User Manual - Inverter Drive Supermarket

9.1.3 Analog output
Chapter 9 Monitor Functions
1) 0 ~ 10V Voltage Output
Group
Code
No.
Function
Display
Initial Setting Unit
01 AO1 Mode 0 Frequency -
OUT
02 AO1 Gain - 100.0 %
03 AO1 Bias - 0.0 %
04 AO1 Filter - 5 msec
05 AO1 Const % - 0.0 %
06 AO1 Monitor - 0.0 %
The items to be output from AO1 (Analog Output 1) terminal of the inverter terminal block are selected and their size
is adjusted.
OUT-01 AO1 Mode : selects the type of the output items.
Setting Function
0 Frequency
Outputs the operating frequency. 10V is produced from the
frequency set at DRV-20 Max Freq.
1
2
3
Output
Current
Output
Voltage
DC Link
Volt
4 Torque
5
Output
Power
10V is produced from 200% of the inverter’s rated current (CT :
based on the Constant Torque).
Outputs the output voltage. Outputs the 10V from set value of
BAS-15 Rated Volt.
In case of BAS-15 set to 0V, it outputs to 10V based on that 200V
class is 220V and 400V class is 440V.
Outputs the DC power voltage of the inverter. 200V class produces
10V at 410Vdc and 400V at 820Vdc.
Outputs the produced torque of 10V at 250% of the motor’s rated
torque.
Monitors the output watt. 200% of the rated output is the maximum
nominal voltage(10V).
6 Idse Outputs the maximum voltage at 200% of no-load current.
7 Iqse
Outputs the maximum voltage at 250% of the rated torque current.
2
2
Rated torque current = rated current − - Non - load current
8
Target
Freq
Outputs the set frequency. Produces 10V at maximum frequency
(DRV-20)
9
Ramp
Freq
The frequency that has gone through acceleration and
deceleration functions and can be different from the actual output
frequency. It produces 10V at maximum frequency (DRV-20)
9-7