SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 6 How to use Keypad
6.1.2 Menu composition
SV-iS7 series inverter consists of the following 5 modes. Each mode has its own function items suitable for the
properties and especially the parameter mode displays the functions necessary for inverter operation in groups.
Movable by left/right key in
Parameter Group
Ex) Drive->Basic Function
Mode Display Description
Monitor mode MON
Displays information on the operating status of the inverter. Can monitor
frequency setting, operating frequency display, output current and voltage, etc.
Parameter mode PAR
Can set functions necessary for operation. Divided into a total of 12 groups,
each suitable for the functional difficulty and objective.
User
mode
& Macro
U&M
You can group only necessary functions by using user group and macro
group. This is not displayed when the user code is not registered or when the
user/macro mode shifts with the mode key unless the macro is not selected.
In case of a failure during operation, the failure type and information on the
operating frequency/current/voltage at the time of the failure occurring are
Trip mode TRP displayed. You can also monitor the type of the trips that previously occurred.
Trip Mode is not displayed when there is no previous failure history during
normal operation.
You can set the use environment for the inverter itself that is not directly related
Config mode CNF
to operating functions such as keypad language selection, monitor mode
environment selection, display of the option card type mounted on the inverter,
parameter initialization and copying.
6-6
Group movable by MODE Key
Ex) Monitor->Parameter
Monitor
Parameter
User&Macro
Drive
Basic Function
Advanced Function
Control
Input Terminal
Output Terminal
Communication
Application
Application Option Card
Protection
Trip
AUT
M2
Config
User
Macro 1
Macro 2