SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 9 Monitor Functions
9-2
Setting Function
terminal of the inverter terminal block.
12 I1 Monitor[%]
Displays the current above in percentage. If the input
current is 0~20[mA], it is represented by 0~100%.
13 V2 Monitor[V]
Displays the voltage input of the V2 terminal of the I/O
option card when you use the extended I/O option.
14 V2 Monitor[%] Displays the V2 input voltage in percentage.
15 I2 Monitor[mA]
The current input into the I2 terminal of the I/O option
card when you use the extended I/O option.
16 I2 Monitor[%]
Displays the input current of the I2 terminal in
percentage.
17 PID Output Displays the output of the PID controller.
18 PID Ref Value Displays the reference of the PID controller.
19 PID Fdb Value Displays the feedback of PID controller.
If the torque reference command method (DRV-08) is set
20 Torque
as methods other than the keypad (0 or 1), the torque
reference is displayed.
If the torque limit setting method (CON-53) is set as
21 Torque Limit methods other than the keypad (0 or 1), the torque limit is
displayed.
If the torque bias setting method (CON-58) is set as
22 Trq Bias Ref methods other than the keypad (0 or 1), the torque bias is
displayed.
If the speed limiting method (CON-62) in the torque
23 Spd Limit
control mode is set as methods other than the keypad (0
or 1), the speed limit amount is displayed.
Displays the load speed in the scale and unit which the
user wants. Displays the load speed in the values to
24 Load Speed which ADV61 (Load Spd Gain) and ADV62 (Load Spd
Scale) are applied in the units of rpm or mpm set in
ADV63 (Load Spd Unit).
2) Output power display
Mode Group Code No.
PAR BAS 18
Function
Display
Trim
Power %
Initial Setting Unit
- 100.0 %
BAS-18 Trim Power % : selects No. 4 Output Power among the monitor items described above, raises this set
value properly when the output power displayed in the loader is lower than expected. If the output power displayed in
the loader is higher than expected, it decreases this set value properly. Output power display is calculated with
voltage and current and Output power can have a error when power factor is low.