SV-iS7 User Manual - Inverter Drive Supermarket

[Example of speed-8]
Chapter 7 Basic Functions
If multi-function terminals P5, P6, P7 and P8 are set at Speed-L, Speed-M, Speed-H and Speed-X respectively, you can
operate it as follows.
IN-89 In Check Time: If you use the multi-function terminal for sequential frequency setting, you can set the in check time
for the terminal block input within the inverter. For example, if you set the in check time at 100msec and input multi-function
terminal P6, it will be checked whether another terminal block input is input for 100msec. After 100msec, it is accelerated
or decelerated by the frequency corresponding to P6 terminal.
7.1.5 Operating command setting method
Group Code No. Function Display Initial Display
0 Keypad
1 Fx/Rx-1
DRV 06 Cmd Source
2
3
Fx/Rx-2
Int 485
4 Field Bus
5 PLC
Select the operating command setting method in DRV Group code 06. For operating command, other than the basic
operation using the keypad and multi-function terminal, you can also use the built-in RS485 communication, Fieldbus
and Application Option Card.
1) Keypad Operating Command: KeyPad
Group Code No. Function Display Initial Display Unit
DRV 06 Cmd Source 0 KeyPad -
If you set the DRV Group 06 with the keypad, operation starts using the FWD and REV keys on the inverter keypad
and stops using Stop key.
Speed FX or RX P8 P7 P6 P5
0 � - - - -
1 � - - - �
2 � - - � -
3 � - - � �
4 � - � - -
5 � - � - �
6 � - � � -
7 � - � � �
8 � � - - -
9 � � - - �
10 � � - � -
11 � � - � �
12 � � � - -
13 � � � - �
14 � � � � -
15 � � � � �
7-11