SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 8 Applied Functions
8.1.3 Up-Down operation
Group Code No. Function Display Setting Display Setting Range Unit
ADV 65 U/D Save Mode 1 Yes 0~1 -
IN
8-6
65~75 Px Define 17 Up 0~48 -
65~75 Px Define 18 Down 0~48
65~75 Px Define 20 U/D Clear 0~48 -
*Px : P1~P8, P9~P11(Option)
You can control deceleration and acceleration by using the multi-function terminal block. This can be used for the system
that uses the upper/lower limit switch output signals of a flow meter, etc. as the acceleration/deceleration command of the
motor.
Group Code No. Function Display Code description
ADV 65
When setting
multi-key jog
REV key
FWD key
U/D
Save Mode
IN 65~75 Px Define
DRV-12 (Acc time)
DRV-11 (Jog frequency)
DRV-13 (Dec time)
DRV-11
- In case of operating command (FX or RX terminal) OFF or a trip
during steady speed operation of in case of power OFF, the
operating frequency is automatically saved in the memory.
- If operation command becomes ON or normal again, operation at
set frequency is available. If you want to delete saved frequency,
use the multi-function terminal block. Set one of the multi-function
terminals at 20 U/D Clear and input the terminal in stop or steady
speed operation, the frequency that was saved in up-down
operation is deleted.
- Sets the appropriate terminal function at 17 Up or 18 Down after
selecting the terminal to use for up-down operation.
- Acceleration follows Up signal during operation and when if is
OFF, acceleration stops and steady speed operation follows.
- Deceleration follows Down signal during operation and when if is
Off, deceleration stops and steady speed operation follows.
- If up and down signals are simultaneously given, acceleration and
deceleration both stop.