SV-iS7 User Manual - Inverter Drive Supermarket

CON-62 Speed Lmt Src : Selects the type of speed limit setting.
0 : Keypad-1, 1 : keypad-2
Chapter 8 Applied Functions
The speed limit is set by using the keypad. The forward speed limit is set in CON-41 FWD Speed Lmt and the reverse
speed limit is set in CON-42 REV Speed Lmt.
2 : V1, 3 : I1, 6 : Int 485
Operates the same way as the frequency command setting method. The setting can be checked in MON mode and
select No.21 Torque Bias from CNF-06 ~ 08.
CON-65 Speed Lmt Gain : Sets the rate of reference decrease when the motor speed exceeds the speed limit. If No. 35
of the multi-function input terminal function items is selected and input during stop, the operation can shift from the torque
control mode to vector control mode(speed control).
8.1.15 Droop control
This can be used to prevent saturation of the speed controller in vector control or for load balancing when one load is
driven by multiple controllers.
Group Code No. Function Display Initial Setting Display Unit
CON
66 Droop Perc - 0.0 %
67 Droop St Torque - 100.0 %
CON-66 Droop Perc : Sets the rate to be reflected in the speed command value on the basis of the motor rated torque.
CON-67 Droop St Torque : Sets the torque at which the droop control operation starts.
The motor speed is adjusted as follows according to the load torque on the basis of the set value.
8.1.16 Speed/Torque change function
This function is active only in vector control. You can shift from the speed mode to torque mode or shift from the torque
mode to speed mode by the multi-function input.
Group Code No. Function Display Initial Setting Display Unit
CON
Torque reference - DroopStTorque
Droop speed =
Maximum frequency×
DroopPerc×
100%
torque - DroopStTorque
68 SPD/TRQ Acc T - 20.0 Sec
69 SPD/TRQ Dec T - 30.0 Sec
IN 65~75 P x Define 35 Speed/Torque -
8-33