SV-iS7 User Manual - Inverter Drive Supermarket

(2) PNP mode (Source mode) – When use inner source
Chapter 4 Wiring
Set NPN (Sink)/PNP (Source) switch into PNP. 24 (24V inner source) is common terminal of contact point input
signal. PNP mode (Source mode) – Set NPN (Sink)/PNP (Source) switch into PNP When use exterior source.
If you want try to use exterior 24V source, connect exterior source (-) terminal with CM (24V GND).
PNP NPN PNP mode (Source mode) – When using inner source
PNP
NPN
External Source
(24V)
24(24V)
P1(FX)
P2(RX)
Inner source (24V)
PNP mode (Source mode) – When using external source
-
+
CM (24G)
P1(FX)
P2(RX)
4-12