SV-iS7 User Manual - Inverter Drive Supermarket

-10 ~ +10 V
Output
Frequency[Hz]
60.00
59.94
0.12
0.06
V1
CM
0.025 0.1 0.2
0.075 0.175
Analog Input[V]
9.925 10
9.975
Chapter 7 Basic Functions
(3) If -10~+10V is input,
Group Code No. Function Display Setting Displayed Setting Range Unit
DRV 07 Freq Ref Src 2 V1 - -
01 Freq at 100% - 60.00 0.00~Max. Freq. Hz
05 V1 Monitor - 0.00 0~10V V
06 V1 Polarity 1 Bipolar Unipolar/ Bipolar -
IN 12 V1 -volt x1’ - 0.00 0~10V V
13 V1 -Perc y1’ - 0.00 0~100% %
14 V1 -Volt x2’ - -10.00 0~10V V
15 V1 -Perc y2’ - -100.00 0~100% %
Set IN-06 at Bipolar. Codes between 12 and 15 are displayed only when they are Bipolar and you can set the voltage
between 0 and 10V which is input into the V1 terminal. As follows, input into the V1 terminal in volume resistance by
using the voltage output of the external controller or the VR output terminal of the inverter control terminal block.
V1
VR+
VR-
When -10~10V is used from the external circuit When connecting inner power source
7-4