SV-iS7 User Manual - Inverter Drive Supermarket

7.1.4 Sequential frequency setting
Chapter 7 Basic Functions
Group Code No. Function Display Setting Displayed Setting Range Unit
DRV 07 Freq Ref Src - - - -
BAS 50~64 Step Freq - x - - -- Hz
IN
65~75 Px Define
7 Speed-L - -
8 Speed-M - -
9 Speed-H - -
10 Speed-X - -
89 InCheck Time - 1 - msec
*Step Freq – x : Step Freq -1~15, Px: P1~P8, P9~P11 (Option)
Sequential operation is available by using the multi-function terminal. Speed 0 frequency uses the frequency
command selected in DRV Group No. 07.
Enter the desired step frequency in codes 50~64 of BAS.
Select the terminal to use as sequential input among multi-function terminals P1~P11 and set one of the sequential
functions (Speed-L, Speed-M, Speed-H, Speed-X) for each.
Speed-L, Speed-M, Speed-H and Speed-X are identified as binary codes and operation starts with the frequency set
in BAS-50 ~ BAS-64 selected.
If multi-function terminals P6, P7 and P8 are set at Speed-L, Speed-M and Speed-H respectively, you can operate it
as follows. In case of Speed-X being used, you can set up to Speed 16 when the highest bit is Speed-X.
Frequency
P6
P 7
8
P
FX
RX
0
1
2
3
4 5 6
7 8
Speed FX or RX P8 P7 P6
0 � - - -
1 � - - �
2 � - � -
3 � - � �
4 � � - -
5 � � - �
6 � � � -
7 � � � �
7-10