SV-iS7 User Manual - Inverter Drive Supermarket

PAR PRT N STP 0.00Hz
00 Jump Code
40 CODE
01 Load Duty
Heavy Duty
02 Phase Loss Chk
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Cmd Torque
0.0 %
2) Group shift in User/Macro Mode
- The group changed in sequence, PRT is displayed.
- Press Right Shift key once.
- You come back to the Drive Group(DRV) of Parameter Group.
Chapter 6 How to Use Keypad
To shift to User/Macro Mode, the user code should be registered or you select the macro function. For user code and
macro group registration, see page 8-47,48, 8.1.30 Addition to User Group (USR Grp) or 8.1.31 Addition to Macro
Group. If the user code is registered and you have selected the macro function, you can shift the group as follows.
MON T/K N STP 0.00Hz
U&M USR U STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Acc Time
20.0 sec
U&M MC1 U STP 0.00Hz
00 Jump Code
1 CODE
01 Acc Time
02 Dec Time
20.0 sec
30.0 sec
U&M USR U STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Acc Time
20.0 sec
- Power on, a display emerges as shown on the left. The present mode is the
monitor mode.
- Press Mode key twice.
- You have shifted to User/Macro Mode(U&M).
- The User Group(USR) is being displayed.
- Press Right key.
- You have shifted to Macro Group(MC1).
- Press Right key.
- You come back to User Group(USR).
6-11