SV-iS7 User Manual - Inverter Drive Supermarket

9.1 Monitor Functions
9.1.1 Monitor in operation - Keypad
Chapter 9 Monitor Functions
You can monitor the operating status using the keypad of the inverter. You can select the desired items to monitor in
the config mode(CNF), watch three items at a time in the monitor mode and select an item in the status display.
1) Selection of Monitor Mode Display
Mode Group Code No.
Function
Display
Initial Setting Unit
- 21 Monitor Line-1 0 Frequency Hz
CNF
-
-
22
23
Monitor Line-2
Monitor Line-3
2
3
Output Current
Output Voltage
A
V
24 Mon Mode Init 0 No -
CNF-21~23 Monitor Line-x : Selects the items to display in the monitor mode. Monitor mode is displayed first when
the power is supplied and all three items of Monitor Line-1 ~ Monitor Line-3 can be displayed simultaneously.
Choose from the following items suited to the line you want to display. If you choose Yes in CNF-24 Mon Mode Init,
CNF-21~23 is initialized.
Setting Function
During stop, the set frequency is displayed and during
0 Frequency operation, the currently output operating frequency is
displayed in Hz unit.
1 Speed The same as above(0) and displayed in rpm unit.
2 Output Current Displays the magnitude of the output current.
3 Output Voltage Displays the output voltage.
4 Output Power Displays the output power.
5
WHour
Counter
Displays the electricity consumed by the inverter.
Displays the DC power voltage inside the inverter. During
6 DCLink Voltage stop, it represents the maximum value of the DC input
voltage.
Displays the status of the input terminals of the inverter
7 DI Status
terminal blocks. From the right, they are represented by
P1,P2…P11.
Displays the status of the output terminals of the inverter
8 DO Status terminal blocks. From the right, they are represented by
Relay1, Relay2, Q1.
9 V1 Monitor[V]
Displays the values being input into V1, the voltage input
terminal of the inverter terminal block in the voltage term.
10 V1 Monitor[%]
Displays the voltage unit above in percentage. If -10 ~ 0
~ +10V is input, it is represented by -100 ~ 0 ~ 100%.
11 I1 Monitor[mA] Displays the magnitude of the current being input into I1
9-1