SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 9 Monitor Functions
* Warning
If you change the default value of Hz/Rpm Sel from Hz to Rpm display, all parameters will be changed to Rpm but it
is not changed automatically in monitor mode.
E.g) At CNF-21 Monitor Line-1 to Frequency (Fault value), if you change the value from Hz to Rpm Display at DRV-
21 Hz/Rpm Sel, Monitor Line-1 set value is not changed. To change the value to Rpm Display in Monitor mode,
CNF-21 set from Frequency to Speed.
9-4
5) Selection of Status Display
Mode
Code
No.
Function Display Initial Setting Unit
CNF 20 AnyTime Para 0 Frequency -
The variables to be displayed at the top of Keypad Display(LCD Display) can be selected. The items available are as
follows and the items not particularly described have the same functions described in the Monitor Mode Selection
Items above.
Setting Function
0 Frequency 13 V2 Monitor[V]
1 Speed 14 V2 Monitor[%]
2 Output Current 15 I2 Monitor[mA]
3 Output Voltage 16 I2 Monitor[%]
4 Output Power 17 PID Output
5 WHour Counter 18 PID Ref Value
6 DCLink Voltage 19 PID Fdb Value
7 - 20 Torque
8 - 21 Torque Limit
9 V1 Monitor[V] 22 Trq Bias Ref
10 V1 Monitor[%] 23 Speed Limit
11 I1 Monitor[mA] 24 Load Speed
12 I1 Monitor[%]